Electrodata, Inc. - Audio, DS0, T1, T3, Ethernet, and STS1 SONET handheld and remote test equipment designed to make telecommunications problem-solving easier.
TAU 2

Handheld T1/E1 Troubleshooting ToolTAU 2 Qtr

 

TAU 2 provides the test access capability of a cross-connect panel (DSX), in a small, convenient, handheld package.  It provides a complete set of MONITOR, IN and OUT bantam jacks for both circuit directions from the test point.  In addition, TAU 2 provides simple switches to loop-back the circuit in either direction.  View the datasheet (PDF).

 
Introducing the ATS-5X

The NCS/Electrodata ATS-5X is a handheld test instrument for complete troubleshooting of audio frequency impairments on communication networks. An intuitive menu, rugged construction and a bright, clear LCD touchscreen make control and operation an enjoyable process.

The ATS-5X measures transmission quality and impairments in the frequency range of 50Hz to 20kHz. Use the ATS-5X to verify signal levels and transmission quality or to identify sources of noise, distortion and interference.  Measurements include: Spectrum, Longitudinal Balance, Impulse Noise, 23-Tone and Echo.  The ATS-5X can function as a telephone handset with dial capability and it can capture DTMF digits which are then analyzed for twist and skew. Captured tests may be stored to your USB device for later analysis or documentation. Simple controls and sophisticated test solutions mean ATS-5X will enable you to troubleshoot your audio network problems quickly and with ease.

Download the complete specifications (PDF). 
ATS-5X
 
COMM-WATCH II
COMM-WATCH II is a comprehensive remote monitor and alarm instrument for telecommunications T1, E1 or J1 circuits.

Comm-Watch II

COMM-WATCH II monitors both the receive (NETWORK) and transmit (SITE) sides of the circuit. It reports failures or alarm conditions and performance measurements of remote network sites.
COMM-WATCH II also provides channel related information for PRI and conventional signaling as well as an extensive capture capability. The user is able to determine whether the failure is network generated or caused by on-site equipment at the remote location

Watch this Short Video  presentation or download the complete specifications (PDF).

 

 

 
EZ-Tester HD

Combined DS3 and Dual Line DS1 Tester

EZ-TESTER HD:  Combined DS3 and Dual Line DS1 Tester

Electrodata's TTS 3,EZ-TESTER® HD represents the most versitile T1 and DS3 transmission test set available. Equipped with the best features and rugged design of the EZ-TESTER Series, the EZ-TESTER HD provides testing support for DS0, T1, and DS3 in a single hand-held test set. The EZ-TESTER HD is available in three basic configurations: DS3 only; DS3 and Single Line DS1; and DS3 and Dual Line DS1.

Read the complete specifications (HTML).

 
ATS 2 Enhanced Audio Test Set

 

The ATS 2 is a full feature audio test set in a portable, hand-held package.  The set facilitates the installation and maintenance of leased or dial-up circuits and equipment connected to the public switched networks.  Designed to comply with IEEE and Bell specifications, the  ATS 2 is capable of performing all basic analog transmission measurements plus Impulse Noise, Signal-to-Noise, and P/AR tests

Read the complete specifications (HTML).
 ATS 2 Enhanced Audio Test Set

 

 

Electrodata Inc., P.O. Box 31780, Independence, OH 44131-0780
E-Mail: sales@electrodata.com Phone: (216)663-3333 or (800)441-6336 Fax: (440)374-4994